Operating instructions
96 Starting engine
VOE 2134355130
Starting engine
See Safety locking system on page 60.
IMPORTANT
Do not hold the key at the STARTING ( ) position for more
than 20 seconds, as this could seriously damage the starting
system. After 2 minutes try to start the engine again.
If abnormal sounds, excessive vibration, or abnormal opera-
tion occurs, turn the key to STOP ( ) position to stop the en-
gine immediately.
NOTE : Mak e sure the safety bar is in the downwa rd (lock-out)
position, otherwise the en gine cannot be started.
At temperature above 0°C (+32°F)
1 Turn engine speed selection switch (A) to the low speed posi-
tion. See Engine speed control switch on page 37.
2 Turn the key to the starting position ( ). See Start switch on
page 94.
3 Release the key when the engine has started.
If the engine dose not start:
4 Wait until the engine has stopped completely.
5 Turn the key back to the stop position ()before a new start-
ing attempt is made.
At temperature below 0°C (+32°F)
1 Turn engine speed selection switch (A) to the low speed posi-
tion. See Engine speed control switch on page 37.
2 Turn the key to the running (preheating) position ( ). See
Start switch on page 94.
3 After preheating indicator is OFF, turn the key to the starting
position ( )
4 Release the key when he engine has started.
If the engine dose not start:
5 Wait until the engine has stopped completely.
6 Turn the key back to the stop position ()before a new start-
ing attempt is made.
WARNING!
After checking for personnel and obs tructions around the
machine, start the engine and sound the horn.
Do not operate the operating levers and switches when
starting.
S80510A
H
G
F
I
rpm
A
S82121
S82122
To Next Page
Loading...
