Operating instructions
92 Before operating
VOE 2134355130
Before operating
General rul es
– Read and understand:
– This Operator’s Manual before you begin to operate the
machine
– Plates and instructions which are attached to the machine
before you begin to operate or service the machine.
– Faults and defects which affect the safety must be remedied
before starting.
NOTE:
The machine should stand in the service position when the
checks are carried out, See Service position on page 120.
– When starting the engine indoors, make sure that the extraction
capacity of the ventilation system is sufficient.
– Always sit in the seat when starting the engine.
– The door must be closed when operating.
– Never operate the machine for long periods without ventilation
(to avoid lack of oxygen).
– Use the lap type seat belt for all operations. This applies both
to operator and any passenger.
– Never operate the machine while under the influence of alco-
hol, medicine or other drugs.
– To avoid getting hands or fingers pinched - keep your hands
away from where there is a risk they could get pinched (covers,
doors, windows etc.).
– When you are entering or leaving the machine, always face the
machine and use the steps and hand-holds. Always use the
three point approach, i.e. two hands and one foot, or one hand
and two feet. Do not jump!
– Do not climb on surfaces which are not intended for this.
– Only use the surfaces which are provided with anti-slip materi-
al.
– Suitable clothing for safe handling should be worn.
– Wear a hard hat for increased head protection.
– The cab has two escape routes: through the door or via the rear
right side window. Smash the window pane with the emergency
hammer. See Emergency exit on page 65.
–Never use communication equipment, e.g.a mobile telephone,
which is not correctly installed in the cab, while the machine is
running. The communication equipment signals may interfere
with important electronics in the electrical system of the ma-
chine. A mobile telephone must be connected to the electrical
system of the machine and connected to an external, perma-
nent aerial according to the instructions of the manufacturer.
– Do not overload the machine. Overloading impairs safety.
WARNING!
Breaking these ru les may lead to an accident, serious
injures or death.
S80644
S82104
S82103
S82105
To Next Page
Loading...
