Configuration File Parameter Guide 112 Back to Contents
VCS752 Administrator and Provisioning Manual
Setting:
provisioning.schedule_mode
Description: Sets the type of schedule check for configuration and firmware files.
Values: disable, interval, weekday Default: disable
Setting:
provisioning.resync_time
Description: Sets the interval (in minutes) between checks for new firmware and/or
configuration files.
Values: 0–65535 Default: 0 (OFF)
Setting:
provisioning.weekdays
Description: Sets the day(s) when the device checks for new firmware and/or
configuration files. Enter a comma-delimited list of weekdays from 0
(Sunday) to 6 (Saturday). For example, 5,6,0 means the provisioning
check will be performed on Friday, Saturday and Sunday.
Values: 0–6 Default: Blank
Setting:
provisioning.weekdays_start_hr
Description: Sets the hour when the device checks for new firmware and/or
configuration files.
Values: 0–23 Default: 0
Setting:
provisioning.weekdays_end_hr
Description: Sets the hour when the device stops checking for new firmware and/or
configuration files.
Values: 0–23 Default: 0
Setting:
provisioning.remote_check_sync_enable
Description:
Enables or disables remotely triggering the device to check for new firmware
and/or configuration files. The file checking is triggered remotely via a SIP
Notify message from the server containing the
check-sync
event.
Values: 0 (disabled), 1 (enabled) Default: 1
To Next Page
Loading...
Need help?
General
