Using the WebUI 80 Back to Contents
VCS752 Administrator and Provisioning Manual
Web Server
To configure Web Server Settings:
1. Enter the HTTP Server port number. The default setting is 80.
2. Enable or Disable Secure Browsing. When enabled, the HTTPS protocol is used, and
you must select the HTTPS server port in the next step.
3. Enter the HTTPS server port number. The default setting is 443.
Certificates
You can add two types of certificates using the WebUI or the provisioning file (see “"file"
Module: Imported File Settings” on page 133). The two types of certificates are:
Device—A single Device Certificate can be uploaded so that other parties can
authenticate the phone in the following cases:
When the phone acts as a web server for the user to manage configurations.
When the phone acts as a client for applications where HTTP is supported.
Server—A web server certificate can also be uploaded using provisioning. This
certificate (also called a trusted certificate) is for server authentication with secured
HTTP transaction in the following applications: SIP signaling, Provisioning,
Firmware, LDAP directory service, and Broadsoft directory service.
Setting Description
HTTP Server port Port used by the HTTP server.
Enable Secure Browsing Sets the server to use the HTTPS protocol.
HTTPS Server port Port used by the HTTPS server.
Changing the Web Server settings will reboot the VCS752.
To Next Page
Loading...
