Configuration File Parameter Guide 142 Back to Contents
VCS752 Administrator and Provisioning Manual
"softkey" Module: Custom Soft Key Settings
The custom soft key settings allow you to select which soft keys can appear on the Idle
screen, the Call Active screen, the Call Held screen and the Live Dial screen. You can also
specify the position of each soft key. Softkeys appear on the VCS752 screen in the same
order as the softkey values you enter. Enter soft key values separated by commas. For
more information, see “Customizing Soft Keys” on page 16. You can specify a maximum of
nine soft keys (three levels) for each parameter.
The soft key settings follow the format softkey.[element].
All the soft key settings are included in the general configuration file.
Setting:
softkey.idle
Description: Specifies the soft keys visible on the idle screen.
Values: blank, dir , call_log, redial,
message, dnd, cfwd, cfna,
cfwd_all, cfwd_busy,
intercom, retrieve, callback,
grp_pickup, dir_pickup, line,
settings, pgm_dial_1,
pgm_dial_2, pgm_dial_3,
bt_connect, bt_device1,
bt_device2
Default: redial, line, bt_device1,
bt_device2, bt_connect,
blank, call_log, blank, dir
Setting:
softkey.call_active
Description: Specifies the soft keys visible on the active call screen.
Values: blank, new, park_call, end,
hold, transfer, conf, xferline,
confline, pri_hold,
pgm_dial_1, pgm_dial_2,
pgm_dial_3, bt_device1,
bt_device2, speaker_audio
Default: end, transfer, conf,
bt_device1, bt_device2,
speaker_audio, xferline,
confline
Setting:
softkey.call_held
Description: Specifies the soft keys visible on the held call screen.
Values: blank, new, park_call,
retrieve, grp_pickup,
dir_pickup, end, resume,
transfer, conf, xferline,
confline, pgm_dial_1,
pgm_dial_2, pgm_dial_3
Default: end,new,resume,transfer,
conf,xferline,confline
To Next Page
Loading...
