Configuration Using the Phone Menus 24 Back to Contents
VCS752 Administrator and Provisioning Manual
Using the Network Setting menu
Use the Network setting menu to configure network-related settings for the VCS752. For
more information about these settings, see “Basic Network Settings” on page 54 and
“Advanced Network Settings” on page 55.
To use the Network setting menu:
1. From the Admin Settings menu, press
or to highlight Network setting, and
then press SELECT.
The Network setting menu appears.
2. Press
or to highlight the desired option, and then press SELECT:
DHCP
Set static IP
VLAN ID
Others (DNS and NTP servers).
To enable or disable DHCP:
1. From the Network setting menu, press
or to highlight DHCP, and then press
SELECT.
The DHCP screen appears.
2. Press
or to select Enabled or Disabled, and then press .
DHCP is enabled by default, which means the VCS752 will get its IP address from the
network. When DHCP is disabled, you must enter a static IP address for the VCS752.
You must be familiar with TCP/IP principles and protocols to configure static IP
settings.
To Next Page
Loading...
