Provisioning Using Configuration Files 86 Back to Contents
VCS752 Administrator and Provisioning Manual
Resynchronization: configuration file checking
You can select a number of options that determine when the VCS752 checks for new
configuration files. This process of checking for configuration files is called
Resynchronization. Resynchronization options are available on the WebUI Provisioning
page, but you can also include them in a configuration file.
The resynchronization options are:
Mode—sets the VCS752 to check for a configuration file only, a firmware update
file only, or both types of file.
Never—configuration file checking is disabled
Bootup—the VCS752 checks for new configuration files when it boots up. Any
updates are applied during the boot-up process.
Remote check-sync—enables you to start a resynchronization remotely using your
hosted server's web portal. The Remote check-sync settings are available only in
the configuration file, not the WebUI.
Repeatedly, at a defined interval from 60 to 65535 minutes (45 days).
VCS752 restart
If the VCS752 needs to restart after an auto-update, the restart happens only after the
device has been idle for one minute.
To prevent users from delaying the update process (auto-updates cannot begin until the
VCS752 has been idle for one minute), or to avoid device restarts that might interfere with
incoming calls:
set the resynchronization interval to a suitable period
upload any new configuration file(s) to your provisioning server after work hours so
that the VCS752 will download the file(s) when there is no call activity.
When you update the VCS752 by importing a configuration file using the WebUI, the device
restarts immediately after applying the new settings, regardless of whether the VCS752 is
idle.
To Next Page
Loading...
