Configuration Using the Phone Menus 25 Back to Contents
VCS752 Administrator and Provisioning Manual
To set static IP for the VCS752:
1. From the Network setting menu, press
or to highlight Set static IP, and then
press SELECT.
If DHCP is disabled, the Set static IP menu appears. If DHCP is enabled, an error
message appears briefly before returning you to the Network setting menu.
2. On the Set static IP menu, enter the static IP address. Use the dial pad and the
soft key to enter characters. Press
or to advance to the next character.
3. Press
and enter the Subnet Mask. Use the dial pad and the soft key to
enter characters. Press
or to advance to the next character.
4. Press
and enter the Gateway. Use the dial pad and the Add dot soft key to enter
characters. Press
or to advance to the next character.
5. Press .
To set the VLAN ID for the VCS752:
1. From the Network setting menu, press
or to highlight VLAN ID, and then
press SELECT.
2. On the VLAN ID menu, press
or to enable or disable the WAN VLan.
3. Press
and enter the WAN VID. Use the dial pad and the soft key to enter
characters. The valid range is 0 to 4095.
4. Press .
To Next Page
Loading...
