Using the WebUI 34 Back to Contents
VCS752 Administrator and Provisioning Manual
Authentication name If authentication is enabled on the server, enter the
authentication name (or authentication ID) for
authentication with the server.
Authentication password If authentication is enabled on the server, enter the
authentication password for authentication with the server.
Dial Plan Enter the dial plan, with dialing strings separated by a |
symbol. See “Dial Plan” on page 35.
Inter Digit Timeout (secs) Sets how long the VCS752 waits after any "P" (pause) in
the dial string or in the dial plan.
Maximum Number of
Calls
Select the maximum number of concurrent active calls
allowed for that account.
Page Auto Answer When set to Auto, enables the VCS752 to automatically
answer when a page is received. This is usually the desired
behavior for paging.
Feature Synchronization Enables the VCS752 to synchronize with Broadworks
Application Server. Changes to features such as DND, Call
Forward All, Call Forward No Answer, and Call Forward
Busy on the server side will also update the settings on the
VCS752 menu and WebUI. Similarly, changes made using
the VCS752 or WebUI will update the settings on the
server.
DTMF method Select the default DTMF transmission method. You may
need to adjust this if call quality problems are triggering
unwanted DTMF tones or you have problems sending
DTMF tones in general.
Unregister after reboot Enables the phone to unregister the account(s) after
rebooting-before the account(s) register again as the
phone starts up. If other phones that share the same
account(s) unregister unexpectedly in tandem with the
rebooting VCS752, disable this setting.
Setting Description
To Next Page
Loading...
