VTI Instruments Corp.
278 EX10xxA/RX1032/EX1044 Function Calls
#define VTEX10XXA_ERROR_CAL_MODE_ONLY
The calibration mode must be > 0.
#define EX1048_ERROR_NO_SERIAL_NUMBER
A device without a serial number has made a call
has that requires a serial number.
#define EX1048_ERROR_NO_MAC_ADDR
A device without a MAC address has made a call
has that requires a MAC address.
#define EX1048_ERROR_CAL_FILENAME_TOO_LONG
The calibration file name has overflowed the
calibration[] buffer set by
vtex10xxA_get_calibration_file.
#define EX1048_ERROR_LOADING_CAL_FILE
The device is unable to load the calibration file
(i.e., the file may not exist).
#define EX1048_ERROR_INVALID_VOLTAGE_RANGE
A channel has been set to an invalid voltage
range (i.e. a thermocouple channel has been set
to 10 V while in voltage mode).
#define EX1048_ERROR_INVALID_RANGE_FOR_TC_CONVERSION
TC conversions can only be in the 67 mV range.
#define EX1048_ERROR_OTD_NOT_ALLOWED_IN_10V_RANGE
Hardware is not useful on this range.
To Next Page
Loading...
