www.vtiinstruments.com
EX10SC Signal Conditioning 289
9) The Sig Conditioner column is used to specify the signal conditioner used in a specific channel.
Note that, in the drop menu, many EX10SC 8B modules are predefined and can be selected.
FIGURE 9-9: SELECTION OF A PREDEFINED 8B MODULE
10) If the required 8B module is not listed (or if another type of signal conditioning module is used), a
custom signal conditioner can be defined. To create a custom signal conditioner, simply click Tools-
>Transducer Library under the menu bar. The Transducer Library and Signal Conditioner
wizard will be shown. Highlight the type of the transducer in the section on the left and click on
Add. The Add Transducer wizard will be shown and it allows the user to enter the information of
the transducer.
FIGURE 9-10: TRANSDUCER LIBRARY AND SIGNAL CONDITIONER WIZARD
To Next Page
Loading...
