VTI Instruments EX1000A - Page 290

VTI Instruments Corp.
290 EX10SC Signal Conditioning
FIGURE 9-11: ADD TRANSDUCER WIZARD
 Name – The name of the new transducer.
 Type – The type of the new transducer. The user can type in the value or choose in the
drop down list by clicking the down arrow in the field.
 Number – This number is important and will be shown up as a new in the channel
configuration page while the user selects to use on channels.
 Manufacturer – The manufacturer of the transducer.
 Coupling Mode – The coupling more of the transducer.
 Conversion Mode – This supports Linear, Polynomial, Lookup Table and Division Table
 The Last Calibration Time – The time of the last calibration.
 Input Unit – The unit of the input signal going into the transducer.
 Output Unit – The unit of the output signal going out from the transducer.
11) Once the signal conditioner is defined, click OK and the new transducer should be shown in the
Transducer Library and Signal Conditioner wizard.
FIGURE 9-12: NEW TRANSDUCER SHOWN IN THE TRANSDUCER LIBRARY AND SIGNAL
CONDITIONER WIZARD