2. Delivery and set up
The machine is packed with care at the factory.
The following should be checked after delivery:
1. Whether the packaging shows damages to be reported or
2. Whether the machine shows transportation damages to be reported If this is the case, we ask you
to communicate this information immediately. Subsequent claims cannot be recognised.
The machine must be set up on a suitable, even and firm surface.
Suitable surfaces are, for example:
■ A tool cabinet (available optionally)
■ A separate workbench with a level surface (spirit level) that is strong enough to carry the weight of
the lathe without bending.
■ A steel plate with a level surface (spirit level)
The machine must be screwed securely to the surface it is set up on. There are holes in the base of
the machine that are designed for this purpose. Good working results and low-vibration operation
can only be ensured when the prerequisites for fixture as set out above are maintained.
The place of set up should be selected in such a way that
■ There is sufficient lighting
■ The electrical power supply with safety socket and earth are installed close enough to the machine
that the power cable is not subject to any strain.
■ The power cable should also be dimensioned in such a way that a multiple socket can be used, for
example, to power a coolant system.
To Next Page
Loading...
