74
18. Coolant system (optional)
18.2 Mounting of the coolant system to the tool cabinet
(optional)
To screw the coolant system to the tool cabinet
proceed as follows:
1. Position both spacer feet’s (3) as shown upon the coolant system (2) and align along the fixing
holes of the coolant system.
2. Place the lathe carefully onto the spacer feet’s and align the fixing holes.
3. Remove both shelf inserts out of the coolant system.
4. Combine the four longer Allen screw’s (included in the scope of delivery) each with a washer and
push these from below, through the bored holes in the coolant system and spacer feet’s, into the
fixture threaded sockets of the lathe bed.
5. To finish the whole process, tighten using an Allen key of size 6.
18. Coolant system (optional)
18.3 Safety regulations for the handling of cooling lubricant
1. Pay particular attention to leaked coolant as this can quickly cause people to slip and caused
accidents as a result.
2. Secure your coolant system in such a way that it cannot be switched on by children. Persons who
have not been trained may not operate the coolant system.
3. Ensure you have a clean workplace, dirty areas can quickly lead to accidents.
4. Never use the coolant system when processing magnesium alloys. In combination with water-
mixed coolants, this may result in flammable gas mixtures which may explode under certain
circumstances.
5. Avoid longer skin contact with the coolant.
6. Use skin protecting creams when handling coolants.
7. Regularly monitor the concentration of the water-mixed coolant.
8. Regularly monitor the pH value of the coolant.
9. Make sure that the coolant is only disposed of in an environmentally friendly way in accordance
with the relevant guidelines. Coolant is a special waste product.
To Next Page
Loading...
