18. Coolant system (optional)
18.2 Mounting of the coolant system to the tool cabinet
(optional)
■ The coolant system (2) is positioned, as shown, on the tool cabinet (1). The two spacer feet’s (3)
are not relevant in this stage.
■ The screws and washers required for assembly are included in the scope of delivery.
To screw the coolant system to the tool cabinet
proceed as follows:
1. Combine the four shorter Allen screw’s (included in the scope of delivery) each with a washer.
2. Open the doors of the tool cabinet.
3. Push the screws from below, through the bored holes in the tool cabinet, into the fixture threaded
sockets and tighten using an Allen key of size 6.
To Next Page
Loading...
