WABECO D2000 - Page 4

4
Contents
12. 3 and 4 jaw lathe chuck 36
13. Operational faults and the elimination of such 37
14. Operating elements 40
14.1 D2000 und D2400 lathes 40
14.2 D3000 lathes 41
15. Drawings and legends 42
15.1 Headstock 42
15.2 Foundation with motor and cover cap for D2000/D2400 44
15.3 Foundation with motor and cover cap for D3000 46
15.4 Change gear quadrant for D2000/D2400/D3000 48
15.5 Transmission und lead screw drive for D2000/D2400/D3000 50
15.6 Lead screw engine for D3000 54
15.7 Tool skid – Longitudinal skid 56
15.8 Tool skid – Transverse skid 58
15.9 Tailstock 60
15.10 Rear bearing with guide rods for D2000/D2400 62
15.11 Rear bearing with guide rods for D3000 64
16. Circuit diagram 66
16.1 for D2000/D2400 66
16.2 for D3000 67
16.2 Key for circuit diagram 68
17. Shavings tank with spray protection wall (optional) 69
17.1 Setting up the shavings tank with spray protection wall 69
17.2 Mounting the shavings tank with spray protection wall on the 70
tool machine cabinet (optional)
17.3 Drawing and legend 71
18. Coolant system (optional) 72
18.1 Setting up the coolant system 72
18.2 Mounting of the coolant system to the 73
tool machine cabinet (optional)
18.3 Safety regulations for the handling of cooling lubricant 74
18.4 Filling the coolant system 75
18.5 Operating the coolant system 75
18.6 Positioning the segmented coolant hose 76
18.7 Controlling the flow of coolant using the coolant shut-off valve 76
18.8 Drawing and legend 77
19. Fixed bezel 79
19.1 Operating the fixed bezel 79
19.2 Drawing and legend 80
20. Moving bezel 81
20.1 Operating the moving bezel 81
20.2 Drawing and legend 82