84
21. Tensioning bracket with milling machine table (optional)
21.1 Mounting of the tensioning bracket with milling machine table
8. Tighten the nut (12) through the use of an wrench in size 16mm.
9. Position the milling machine table (6) upon the pivot of the longitudinal skid.
10. Position both push pieces (8) in the lateral bored holes of the milling machine tables‘.
11. Align the milling machine table and arrest the same through tightening both screws (3) using an
Allen key of size 4.
12. Plug the included dust cover (4) into the center hole of the transverse skid.
The positions 1, 2, 3, 5, 11 and 12 are not included in the scope of delivery. They belong to the
lathe.
To Next Page
Loading...
