EasyManua.ls Logo

Wacker Neuson 2503

Wacker Neuson 2503
280 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3-108 OM 25-3503 us – Edition 4.1 * * 2503_3503b340.fm
Operation
Further recommendations for digging
When planning and performing digging work, we recommend that you observe the following
points:
Exits from pits must be outside the digging line and as level as possible
Dig by removing adjacent strips if possible
Ensure that you can drive forward when driving out of the digging area with a fully
loaded bucket
Whenever possible, perform reverse machine travel when transporting a full bucket
down a steep slope
Loading vehicles
When loading vehicles, we recommend taking the following into account:
If possible, the vehicle and the working direction of the bucket should form an angle of 4
Raise the full bucket to dump height only as you rotate toward the vehicle
If possible tilt out with the wind behind you to keep the dust away from your eyes, air
filters and fans
Freeing the machine
If your machine gets stuck in the ground:
Dump out the bucket until the blade is vertical above the ground
Lower the boom all the way
Slowly dump out the bucket
The machine is pushed backward
Reverse slowly
Repeat this procedure until the tracks reach firm ground
Reverse the machine away
Loading vehicles

Table of Contents

Related product manuals