Wacker Neuson 2503

OM 25-3503 us – Edition 4.1 * 2503_3503b510.fm 5-9
Maintenance
Checking the coolant level
☞ Proceed as follows:
•Park the machine on level ground
•Stop the engine!
•Raise the control lever base
•Remove the key and carry it with you
•Let the engine and the coolant cool down
•Open the engine cover
•Tier III: Check the coolant level on the transparent coolant reservoir A and on
the radiator
☞ If the coolant level is below the LOW seam or if there is no coolant at the radiator’s
filler inlet:
➥ Add coolant
•Tier IV: check the coolant level on sight glass B
☞ If the coolant level is below the FULL mark:
➥ Add coolant
Information!
Check the coolant level once a day.
We recommend checking it before starting the engine.
NOTICE
Do not mix the coolant with other coolants.
• Use only the coolant prescribed by Wacker Neuson
– see chapter 5.16 Fluids and lubricants on page 5-35.
Fig. 271: Coolant reservoir
FULL
LOW
A
Fig. 272: Radiator
B
FULL