Operation G 150 / 180 / 240
wc_tx000867gb.fm 32
Locking the
voltage
selector
switch
The voltage selector switch is equipped with a locking mechanism. This allows
the voltage setting to be locked in place to prevent unauthorized personnel
from changing the voltage selection.
To lock the voltage selector switch in position, push the locking mechanism up
and attach a padlock through the openings in the locking strip.
2.10 Emergency stop switch
Location
The emergency stop switch is activated by pressing the red button located to the
left of the control panel. The button can be accessed with the panel doors closed. It
is electrically isolated from the switch and also from the rest of the metering panel.
Operation
Activate the emergency stop switch by pressing the red button.
Activating the emergency stop switch opens the main circuit breaker and the
fuel solenoid, and results in the engine shutting down.
The switch will remain activated until the button is pulled out.
NOTICE: Press the emergency stop button only in the case of an actual
emergency where the generator must be stopped immediately! In all other
instances, open the main line circuit breaker and then turn the engine start switch
to off “O”.
E
M
E
R
G
E
N
C
Y
S
T
O
P
wc_gr005202
To Next Page
Loading...
Need help?
General
