G 150 / 180 / 240 Operation
wc_tx000867gb.fm 49
2.31 Towing
Provided
equipment
The generator trailer is equipped with brakes, lights, and coupler connection.
Prerequisites
Before towing the generator:
Check that the towing vehicle and hitch have a rating equal to or greater than
the GVWR. See Technical Data.
Check the condition of both the coupler and hitch. DO NOT tow the trailer if the
coupler or hitch is damaged.
Make sure that the hitch and coupler are compatible. The generator trailer is
equipped with a pintle type coupler (a).
Check that the directional and running lights on the trailer are working.
Connect the safety chains (c) using a crossed pattern under the trailer tongue.
On trailers with surge or electric brakes, connect the breakaway cable (b) on
the trailer coupler to the rear bumper or frame of the vehicle. This cable will
actuate the brake system on the trailer if both the coupling and safety chains
have failed. The breakaway cable is not a parking brake and should not be
used as one.
Check that all fasteners on the coupling are secure.
Check the tread wear and inflation on the tires. Make sure that all lug nuts are
in place and are tight.
Check the operation of the brakes by braking the vehicle at a slow speed
before entering traffic. Both the vehicle and the trailer should brake smoothly. If
the trailer seems to be pushing, check the fluid level in the surge brakes or the
operation of the electric brakes.
Licensing
requirements
In most states, large trailers must be registered and licensed by the State
Department of Transportation. Before towing, be sure to check licensing
requirements.
Drivers towing trailers may be required to carry a commercial driver’s license
(CDL). Check your local and state licensing regulations before towing the
generator.
Coupler
maintenance
A film of grease on the coupler will extend coupler life and eliminate squeaking.
Wipe the coupler clean and apply fresh grease each time the trailer is towed.
wc
r005197
a c b
To Next Page
Loading...
Need help?
General
