Operation G 150 / 180 / 240
wc_tx000867gb.fm 34
2.12 Engine start switch
Location and
description
The engine start switch (e) is located on the right side of the control panel. It is a
three-position switch: “REMOTE START,” off “O,” and “START/RUN.”
Operation
REMOTE START position:
The REMOTE START position is the normal setting when the generator is
being operated as a back-up power supply connected to a remote switch.
In the REMOTE START position, the generator is in standby mode and will not
start until the remote switch closes.
START/RUN position:
In the START/RUN position, the switch immediately launches the engine start
cycle and activates the starter motor to crank the engine.
Off “O” position:
In the off “O” position, power to the engine’s electrical system, including the fuel
solenoid, is disconnected.
Note: When set in the REMOTE START or START/RUN position, the engine start
switch applies battery power to the control module to turn on the LCD panel, and
also energizes the engine’s electrical system.
To Next Page
Loading...
Need help?
General
