39
C
SURFOX 306
USER MANUAL
• The polishing process requires a greater
amount of electrolyte solution than pickling.
• Always keep the pad/brush well moistened
with the electrolyte solution to avoid
overheating and a consequent signicant
reduction in its working life; if there
are obvious signs of wear, replace the
component immediately.
• If the power and/or voltage is increased
during processing, the electrolyte solution
evaporates more quickly; make sure that
the pad or brush is always wet.
• Never use an insert without its matching
pad; the insert must never be placed in
direct contact with the steel workpiece.
• When carrying out cleaning/polishing, keep
the brush perpendicular to the weld and
never press the carbon bristles excessively
against the surface to be treated (C).
• For best results, periodically adjust the PTFE
sleeve of the brush to leave approximately
5/8" (15 mm) of carbon ber is exposed.
NO!
To Next Page
Loading...
