WarmFlow Agentis Series User Manual

Page 68
11. Confirm the setting and move to the next time to be modified by pressing the Time
Programming button (4).
12. When finished programming the off time, confirm the setting by pressing the Time
Programming button (4) which will return the LCD to step 7 allowing another time slot to
be selected. To select a different day for programming, return to step 5 by pressing the
Mode button (3) for 1 second.
13. Repeat the steps as required to modify the Time Slot ON and OFF time settings. The
settings are saved and the LCD returns to the Home Screen when no button presses are
detected for a short period of time.
14. It is possible to copy settings from one day to another, see Section 6.6.3.
To disable a time Slot, set the ON and OFF times to the same value, ‘----‘ will be displayed as
the time setting once the off time is confirmed with the Time Programming button (4).
6.6.3 Day Copy
It is possible to copy either CH or DHW settings from one specific day to another day.
1. From the Home Screen, Press the Time Programming button (4) for 3 seconds
2. The LCD will display ‘tinE’ representing Time. Note: This menu can only be accessed
if the internal time programmer is enabled for CH or DHW. See sections 11.7.1 and
11.7.2 for enabling the programmer.
3. Press the DHW+ button (1) to select either DHW or CH Time Programming, the radiator
icon or tap icon will flash when selected.
4. Press the mode button (3) for 1 second to enter the required Time Programming Menu.
5. The word will flash. Use the DHW+ button (1) or DHW- button (2) to select the
day to be copied.
6. Press the DHW+ button (2) and Mode button (3) simultaneously for 3 seconds, the LCD
will display ‘COPY SrC’, the settings are copied into a temporary buffer.
7. Press the Mode button (3) for 1 second to return to the day selector.
8. Press the DHW+ button (1) or DHW- button (2) to select the required destination day.
9. Press the DHW- button (1) and Mode button (3) simultaneously for 3 seconds, the LCD
shows ‘COPY dSt’, the settings are copied to the destination day. It is possible to paste
the settings to multiple days as required by repeating these steps. The settings are
saved and the LCD returns to the Home Screen when no button presses are detected for
a short period of time.

WarmFlow Agentis Series Specifications

General

Installation Type	Wall-mounted
Type	Condensing
Dimensions	700 x 400 x 300 mm
Efficiency	Up to 93%
Control	Digital
Heating Capacity	Varies by model
Warranty	5 years