WarmFlow Agentis Series - Advance Mode; Continuous Mode

Page 70
6.6.6 Advance Mode
Advance is a temporary override, setting the DHW or CH function OFF if it was ON, and ON if it
was OFF until the next Time Slot.
To Advance CH, press the CH+ button (7) for 3 seconds and then rapidly press the CH+ button
(7) to select ‘Adv’.
To Advance DHW, press DHW+ button (1) for 3 seconds and then rapidly press the DHW+
button (1) to select ‘Adv’.
The Function starts when no buttons are pressed for 5 seconds.
6.6.7 Continuous Mode
Continuous is a permanent override, setting the DHW or CH function ON until the override is
switched off by the user.
To activate Continuous CH, press CH+ button (7) for 3 seconds and then rapidly press to select
‘Cont’.
To activate Continuous DHW, press DHW+ button (1) for 3 seconds and then rapidly press the
DHW+ button (1) to select ‘Cont’.
The Function starts when no buttons are pressed for 5 seconds.