128 Creating PowerLine Methods
6.4.3 Entering Parameter Values in the Method Table
Note: When the Program Methods table (see Figure 6-14) first appears, the Step 1 line
contains default values. You can modify these values if you wish. For subsequent lines,
the system automatically provides step numbers when you press the Insert Line screen
key or when you type values on a new line and press Enter.
To enter parameter values into the Program Methods table (see Figure 6-14):
1. Move the cursor to the First Vial field.
2. Type the number of the vial from which you want to make the first injection. Press
Enter. The system automatically assigns a step number.
• When using a Waters PowerLine autoinjector, the vial number can be any value
between 1 and 48 or 1 and 96, depending on the autoinjector carousel.
Special Vial Codes
• When using the manual injector or a non-PowerLine autoinjector, enter one of
the special vial codes described in Table 6-6.
Save Saves the table currently displayed and erases the previous
values. You must save the table before leaving this screen.
More Displays additional screen keys (Clear Table and Recall)
associated with the method table.
Help Displays the Help screen associated with the Program
Methods screen.
Table 6-6 Special Vial Codes
Vial Code Function Description
100 Manual Inj Tells the controller that you will make the
injection with the manual Rheodyne
injector or a non-PowerLine autoinjector.
101 Equilibrate Equilibrates the system at initial condi-
tions for the specified run time.
Table 6-5 Program Methods Screen Keys (Continued)
Key Function
To Next Page
Loading...
