45
Chapter 4
Setting PowerLine Controller
Operating Parameters
This chapter contains the information you need to set the operating parameters for the
PowerLine modules using the 600 controller.
The operating parameters apply to all controller operations, whether you are running a
direct-control or a timed multimethod application. Once you set these parameter values,
they remain in memory until you change them.
Note: For a detailed description of using the 600 controller as a Gradient Controller, see
Section 2.4.2, Gradient Controller Configuration. For instructions on configuring and using
your Waters 600 Controller as a Gradient Controller, see Chapters 8 through 11.
When to Use the PowerLine Controller
Use PowerLine Controller mode when you want to control other devices (such as,
detectors, autosamplers, and integrators) from the 600E system.
For a detailed description of PowerLine Controller mode, see Section 2.4.1, PowerLine
Controller Configuration.
Background Information
This chapter assumes that you have installed your system according to the instructions in
the Waters 600E Multisolvent Delivery System Installation and Maintenance Guide.
Ensure that you have read Chapters 1 through 3, in this manual and that you have:
• Acquainted yourself with the system (Chapter 1, Introduction)
• Familiarized yourself with basic operation and decided upon a controller
configuration (Chapter 2, Basic Operation)
• Prepared your system for operation (Chapter 3, Preparing Your 600E System for
Operation)
If you have not completed the tasks listed above, do so now.
To Next Page
Loading...
