Waters 600 - 4.4 Setting Up the Autoinjector

Setting Up the Autoinjector 71
4.3.3 Exiting the Pump Setup Screen
1. Press any one of the following screen keys to select another screen:
• Next Setup - Displays the Autoinjector Setup screen
• System Config - Displays the System Configuration screen
• Pump Config - Displays the Pump Configuration screen
2. Press one of the function keys to enter a different mode.
4.4 Setting Up the Autoinjector
Refer to this section when using a PowerLine autosampler (Waters 717plus) in your
system.
This section describes:
• Accessing the Autoinjector Setup screen
• Setting Autoinjector Setup parameters
• Exiting the Autoinjector Setup screen
Note: Make sure the Waters 600 controller has recognized the autoinjector on the
IEEE-488 bus before performing this procedure. See Section 4.2, Verifying that
PowerLine Devices Are Active, for more information.
Figure 4-15 illustrates the steps involved in using the Autoinjector Setup screen. Use this
flowchart as a quick reference for setting the parameters on the Autoinjector Setup screen.