3.1.2 Configuring the system software
To configure the system software:
1. Ensure that the latest version of MassLynx software is installed on the workstation.
Note: Verify that the MassLynx software version is compatible with the mass
spectrometer. Visit https://support.waters.com/KB_Inf/MassLynx/
WKB554_What_is_the_latest_version_of_MassLynx_SCN_that_supports_my_MS_instrum
ent for latest updates.
See also: For MassLynx installation or upgrade information, see the MassLynx 4.1
Getting Started Guide located on your documentation CD. For software change note (SCN)
details, see the associated release notes on the Waters website for the appropriate SCN.
2. Install the ACQUITY UPLC M-Class Driver Pack, update your module firmware, and
configure your inlet and system modules.
See also: You must refer to the Waters Driver Pack 2019 Release 2 Installation and
Configuration Guide on the software media CD for successful installation of the driver
pack. For complete details about supported firmware, software, and operating systems,
see the Waters Driver Pack 2019 Release 2 Release Notes (716006267).
3.1.3
Monitoring LEDs
LEDs on each system module indicate its state of functioning. The LEDs are specific to their
modules, so the significance of their various colors and modes can differ from one module to
another.
Tip: You can monitor the instrument console for messages and LED indications.
3.1.4
Power LED
The power LED, on the left-hand side of a system module’s front panel, indicates its power-on or
power-off status.
Table 3–1: Power LED indications
LED mode and color Description
Green Power is on.
Black (unlit) Power is off.
3.1.5 Status LEDs
November 26, 2019, 715003588 Revision C
Page 49
To Next Page
Loading...
