Preparing the column compartments 49
2. Disconnect the power and Ethernet cables from the rear panel of the
CM-A and detector.
3. Remove all solvent bottles from the bottle tray.
4. Remove the solvent tray from the system stack.
5. Disconnect the detector’s waste tubing and the inlet tubing from the
CM-A outlet.
6. Remove the detector from the system stack.
7. Place the CM-Aux on the CM-A.
8. Place the detector on the CM-Aux.
9. Place the solvent tray on the detector.
Warning: To avoid injuries arising from personal contact with
spilled solvent, remove the solvent bottles from the solvent tray
before removing the solvent tray.
To Next Page
Loading...
