Preparing the column compartments 51
13. Connect the Ethernet cables to the rear panel of the CM-A and detector.
Rear view of repositioned instruments:
Setting up waste management
To set up the waste management components:
1. Route a waste line from the barbed fitting on the rear of the solvent tray
to a suitable waste container.
2. Route the waste tube from the detector to the solvent manager drip tray
(using the backpressure regulator) or to another in-line detector.
Detector
CM-Aux
CM-A
Sample manager
Solvent manager
Bottle tray
External control cable
To Next Page
Loading...
