Waters ACQUITY - Materials of Construction and Compatible Solvents; Preventing Contamination; Running Hexane and THF with the ACQUITY QDa Detector

To connect the column module:
Notice: To avoid damaging the electronic components of the sample manager
and the column heater or column heater/cooler, always power-off the sample
manager and column heater/cooler before connecting or disconnecting the
interconnect cable.
1. Make sure the sample manager and the column module are powered-off.
2. Connect the interconnect cable to the High Density (HD) port on the rear of the column
module.
3. Connect the other end of the interconnect cable to the QSPI port on the rear of the sample
manager.
August 8, 2016, 715005049 Rev. C
Page 74