上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD
2 / 52
4.3 Execute Cycle Machining .............................................................................................. 30
4.4 Execute Array Machining ............................................................................................. 30
4.5 Execute the Program Task ........................................................................................... 32
4.6 Simulate Machining ........................................................................................................ 34
4.7 Execute MDI ...................................................................................................................... 35
4.8 Guide Machining by the Handwheel ........................................................................ 36
5 Common Operations ................................................................................................................... 37
5.1 Conduct a Simulation Test on Ports ......................................................................... 37
5.2 Modify System Parameters ......................................................................................... 38
5.3 Back up System Parameters ....................................................................................... 39
5.4 Check System Logs ......................................................................................................... 41
5.5 Save and Recover Coordinates................................................................................... 42
5.6 Check Machining Statistics .......................................................................................... 44
5.7 Compensate the Tool ..................................................................................................... 45
5.8 Compensate Screw Error ............................................................................................. 46
5.9 Execute Instant Calibration ......................................................................................... 48
6 System Management .................................................................................................................. 49
6.1 Register the System ........................................................................................................ 50
6.2 Switch the System Language ...................................................................................... 50
6.3 Maintain the System ...................................................................................................... 51
6.4 Use NcCloud Assistant ................................................................................................... 51
6.5 Set the Network ............................................................................................................... 51
7 Advanced Operations ................................................................................................................. 52
To Next Page
Loading...
Need help?
General
