上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD
32 / 52
4.5 Execute the Program Task
This operation is used to put several program files into a task by setting machining
order, machining interval, used WCS and machining times for each program file.
Before executing the program task, ensure that there are several program files in
the local or USB flash disk.
To execute the program task, do the following:
1. Create a program task.
2. Edit the program task.
3. Start the program task.
4.5.1 Create a Program Task
To create a new program task, do the following:
1. To enter into Program Task interface, press → =:
2. To create a new program task, press F2 → F1. A program task named as New
Task + No. shows.