上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD
36 / 52
2. To enter into User Code interface, press → C:
3. To move the cursor to the target line, e.g. line (3), press ↑ / ↓.
4. Press Insert, and input a command.
5. To execute the command, do one of the following :
– Press F3.
– Press Enter.
4.8 Guide Machining by the Handwheel
This operation is used to manually control the automatic execution speed of the
machining program during automatic machining, so as to guard against dangers
caused by a wrongly loaded program or an inappropriate toolpath.
Before guiding machining by the handwheel, connect the handwheel.
To Next Page
Loading...
Need help?
General
