上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD
30 / 52
2. Select a kind of wizard:
– T: CirFrame
– S: CirPocket
– P: RecFrame
– Q: RecPocket
– L: LaMeasure
3. Set related parameters.
4. To generate a program file and save it, press F3.
5. To load the program file, press F1.
If you need to unload the file, press F2.
4.3 Execute Cycle Machining
This operation is used to complete all machining actions with a program file for
batch machining, carving machining, etc.
Before executing cycle machining, do the following:
1. Return to the machine origin.
2. Load a program file.
To execute cycle machining, do the following:
1. To enter into AUTO mode, press .
2. To enter to Coor-Auto interface, press → A.
3. To set machining times of the current program file, set the value of parameter
Prog Cycle Times.
4. Find Parameter Cycle Machining Interval, and set the interval between two
machining tasks for cycle machining.
Note: After restating the software or reloading the program file, cycle times will be cleared and you need
to set it again.
4.4 Execute Array Machining
This operation is used for batch machining of the currently loaded program file, so
as to improve machining efficiency.
To Next Page
Loading...
Need help?
General
