上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD
29 / 52
3. To start machining according to the actual demand, select the start line:
– To start machining from the beginning of the program file, press T.
– To start machining from the set line, press S and manually input the
start line.
4. To stop machining according to the actual demand, select the end line:
– To stop machining till the end of the program file, press P.
– To stop machining till the set line, press Q, and manually input the end
line.
The system automatically starts machining from the set start line to the set end line.
4.2 Generate a Wizard File
This operation is used to generate a wizard file by program wizard.
To generate a wizard file, do the following:
1. To enter into Prog Wizard interface, press → C:
To Next Page
Loading...
Need help?
General
