上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD
26 / 52
2. To enter into Coor-Auto / Coor-Manual interface, press → A.
3. To start mobile calibration, press F5 → F5.
The system calculates calibration result and set it into the workpiece offset:
Workpiece offset = Machine coordinate - Mobile presetter thickness - Pu
blic offset - Tool offset
Generally, the default setting values of public offset and tool offset are both 0.
3.4.4 Set the Offsets
This operation is used to set the workpiece offset and the public offset. The former is
used to show the distance of the workpiece origin relative to the machine origin,
while the latter is used to adjust the workpiece origin of X-axis, Y-axis and Z-axis for
all WCSs.
To set the offsets, do the following:
1. To enter into Coor-Manage interface, press → A:
To Next Page
Loading...
Need help?
General
