WEIHONG NK200 - Page 144

Specialized Concentrated Focused
「132」Parameter Overview
Name
Setting Range
Default
Effect Time
Reference
Acceleration of
handwheel
0~100000
200
After reboot
3.14
Full feedrate for G00
Yes: Use; No: Not use
Yes
After reboot
3.14
Feedrate is valid for
manual mode
Yes: Valid; No: Invalid
Yes
After reboot
3.14
Use default speed
Yes: Valid; No: Invalid
Yes
3.6.1
Use default spindle
speed
Yes: Valid; No: Invalid
Yes
Immediately
3.5.1
Back to reference
point before
machining
Yes: Valid; No: Invalid
Yes
Immediately
3.4.4
Whether to cancel the
mark of backing to the
reference point after
E-stop
Yes: Valid; No: Invalid
Yes
Immediately
3.4.4
Is reset SVON when
estop
Yes: Valid; No: Invalid
No
Immediately
3.4.4
Max angle of joining
high speed
0~180.001 deg
120
Immediately
3.6.3
Corner trace
pretreatment options
0:Not disposed;
1:Curve smooth;
3:Arc smooth
0
Immediately
3.6.3
Corner tolerance
0~0.5001 mm
0.1
Immediately
3.6.3
Conner speed look
ahead distance
0~0.05 mm
0
Immediately
3.6.3
Predicted segment
No.
0~100
50
Immediately
3.6.3
Whether to use type S
algorithm
Yes: Use; No: Not use
1
Immediately
3.6.3
Plunge speed option
0: Not disposed;
1: Direct Z motion only;
2: General Z down motion
0
Immediately
3.6.3
Z down speed
0~ Max Z-axis speed
300
Immediately
3.6.3
Z deceleration
distance
0~999 mm
10
Immediately
3.6.3
Z approach speed
0~default feeding speed mm/min
600
Immediately
3.6.3