WEIHONG NK200 - Parameters Specifications

Specialized Concentrated Focused
「30」Operation
 [Back to Manual]
The shortcut key is F7, only available under [Manual] function section.
After F7 is pressed, the manipulation button bar will return to the previous one.
3.4.4 Parameters Specifications
 Related Parameters of Safe Operations:
Parameter
Definition
Setting Range
Back to refer before
machining
Whether backing to machine origin before
machining is a must or not.
True: Forced
False: Not forced
Backing to the reference
point mark whether
cancelled after E-stop
Whether the mark of backing to the machine
origin will be cleared or not once E-stop
occurs.
True: Cleared
False: Not cleared
Returning to the machine origin before machining can prevent machining offset, ensuring position
precision. It is recommended to set “True” for parameter “Backing to the reference point mark
whether cancelled after E-stop” so that once E-stop occurs, the mark will be cleared, and the
system will remind users to back to machine origin. If parameter “Back to refer before machining” is
set “True” and there is no mark “ ” before each axis, the machine is not allowed to move until
backing to machine origin is finished. And it can be set “False” when returning to machine origin is
impossible due to origin switch error.
 Related Parameters in the Process of Backing to Machine Origin
Parameter
Definition
Setting Range
X direction in back to refer
It sets the direction of X axis in coarse
positioning stage of backing to machine origin.
-1;1
Y direction in back to refer
It sets the direction of Y axis in coarse
positioning stage of backing to machine origin.
-1;1
Z direction in back to refer
It sets the direction of Z axis in coarse
positioning stage of backing to machine origin.
-1;1
Retract distance of X-axis
It sets retract distance of X axis after fine
positioning of backing to the machine origin.
-
Retract distance of Y-axis
It sets retract distance of Y axis after fine
positioning of backing to the machine origin.
-
Retract distance of Z-axis
It sets retract distance of Z axis after fine
positioning of backing to the machine origin.
-
X speed in back to refer
It is the speed of X axis at the stage of coarse
positioning.
0.001~15000
mm/min
Y speed in back to refer
It is the speed of Y axis at the stage of coarse
positioning.
0.001~15000
mm/min
Z speed in back to refer
It is the speed of Z axis at the stage of coarse
positioning.
0.001~15000
mm/min