Specialized Concentrated Focused
Operation「29」
Fig. 3-13 Interface of Backing to Machine Origin
[X Back]
The shortcut key is F1, only available under [Manual] function section.
After F1 is pressed, the system will execute the operation of backing to machine origin for X axis.
After this operation is finished, a mark of will appear before [X] axis indicating the finish of backing
to machine origin.
[Y Back]
The shortcut key is F2, only available under [Manual] function section.
After F2 is pressed, the system will execute the operation of backing to machine origin for Y axis.
After this operation is finished, a mark of will appear before [Y] axis indicating the finish of backing
to machine origin.
[Z Back]
The shortcut key is F3, only available under [Manual] function section.
After F3 is pressed, the system will execute the operation of backing to machine origin for Z axis.
After this operation is finished, a mark of will appear before [Z] axis indicating the finish of backing
to machine origin.
[All Back]
The shortcut key is F4, only available under [Manual] function section.
Similar to the above situations, after F4 is pressed, the system will execute the operation of backing to
machine origin for all the three axes.
After this operation is finished, a mark of will appear before [X], [Y] and [Z] axis indicating the finish
of backing to machine origin.
To Next Page
Loading...
