Specialized Concentrated Focused
Operation「61」
Return
Pressing shortcut key F7 will return to the previous interface.
3.13 Program File Management
Program file management manages the processing files in the system, related to the operations of
processing program.
3.13.1 Program Wizard
NK200 offers 5 basic processing program wizards: circular frame, circular pocket, rectangular frame,
rectangular pocket and laser measure. Users just need to input some simple parameters to complete the
milling operation of circular frame and rectangular frame, etc. Take laser measure as example:
Under SF1 [Auto] function section, press F3 to enter [Program wizard] and then press shortcut key L to
switch to laser measure screen, as shown below. Users can set parameters for the selected object as
required to achieve the desired result.
Fig. 3-47 Laser Measure
[LaMeasure]: the wizard for screw error measured by a laser interferometer. The data file generated with
this wizard can be used for backlash compensation.
After the input of Start Position, End Position, Num Points, Num Runs and Pause Interval, the system
will automatically record the error of each num point (measure point) and then output the compensation
file by the laser interferometer.
After parameter values are entered, press F3 to save them, the system automatically generating the
program, then press F1 to load the program, and then press “Program Start” to begin measuring.
To Next Page
Loading...
