WEIHONG NK200 - Software Interface

Specialized Concentrated Focused
「46」Operation
G54 P0 Use extended coordinate system1 Select extended coordinate systemG154
G54 P1 Use extended coordinate system 2 Select extended coordinate systemG155
G54 P2 Use extended coordinate system 3 Select extended coordinate systemG156
G54 Px Use extended coordinate system(x+1) Select extended coordinate system(154+x)
G54 P19 Use extended coordinate system 20 Select extended coordinate systemG173
3.8.3 Software Interface
Press SF3 to enter [Offset] function section, as shown in Fig. 3-32. In this interface, users can see the
workpiece coordinate currently edited, the corresponding workpiece offset and public offset.
Fig. 3-32 [Offset] Function Section
Press shift key “↑” or “↓” to move to workpiece offset or public offset, and then press [Enter] key to modify;
for the modification of Z-axis public offset, the more convenient way is to press [Deepen] or [Raise]
button.
As for the manipulation buttons under this function section, they will be introduced in the following part.
 [Select WCS]
Press F1 “Select WCS” to select the desired workpiece coordinate system. Each time pressing F1 will
select a WCS for G54 to G59 in the sequence of end-around ascending.
 [Set_X], [Set_Y] and [Set_Z]
After one of their shortcuts F2, F3 and F4 is pressed, the workpiece offset of workpiece coordinate of the
corresponding axis (X/Y/Z) in the current WCS will be set as the value of current mechanical coordinate,
while the corresponding YZ/XZ/XY will stay the same.
 [Select Distance]
The shortcut key is F5, only valid under [Offset] function section.
After F5 is pressed, the value of “Axis Z Deepening and Raising Distance” will be modified with 5 options:
0.01mm, 0.10mm, 0.50mm, 1.00mm, and 5.00mm.