WEIHONG NK200 - Parameter Overview; Operation Parameters

Specialized Concentrated Focused
Parameter Overview「131」
6 Parameter Overview
Since the parameter number in NK200 is not fixed and varies with the software upgrade or system
update, it is recommended to locate the needed parameters by its name.
Name
Setting Range
Default
Effect Time
Reference
3. Operation parameter
Manual high speed
Manual low speed~ max speed of
each axis mm/min
3500
Immediately
3.6.1
Manual low speed
0~Manual high speed mm/min
1500
Immediately
3.6.1
Dry running speed
Defalut feeding speed~ max speed
of each axis
3500
Immediately
3.6.2
Machining speed
0.001~Dry running speed
3000
Immediately
3.6.2
Safe height
0~500 mm
10
Immediately
3.6.3
Single axis acc
0.001~100000 mm/s
2
800
Immediately
3.6.3
The delay time of cute
angle motion
-
0
Immediately
3.6.3
Startup speed
0~
0
Immediately
3.6.3
Max machining speed
Machining speed~max speed of
each axis mm/min
10000
Immediately
3.6.3
Rough speed of cali
1~ manual high speed mm/min
400
Immediately
3.7
Cali block thickness
0~100 mm
10
Immediately
3.7
X mechanical coor of
fixed cali
X/Y/z workbench lower limit~X/Y/Z
workbench upper limit
0
Immediately
3.7
Y mechanical coor of
fixed cali
0
Immediately
3.7
Z mechanical coor of
fixed cali
-1
Immediately
3.7
Handwheel output
direction
1:handwheel output direction same
with feeding direction
-1:hanwheel output direction
opposite to feeding direction
1
After reboot
3.14
Handwheel in strict
accordance with the
pulse-counting
exercise
Yes: Valid;
No: Invalid
No
After reboot
3.14