Specialized Concentrated Focused
Operation「49」
The three points should be apart from each other as far as possible for the accuracy of the circle center.
3.10 Simulation and Track
3.10.1 Simulation
The function of simulating provides a fast but lifelike simulated processing environment for users.
Running under the mode of simulating, the system will not drive the machine tool to do the relative
actions but only show the processing trace of the cutter in high speed in the trace window. By simulating,
users see moving form of the machine tool in advance, avoiding machine tool damage due to
programming mistakes in processing procedure. And they can also know other additional information.
The steps of simulation are as below:
1) Under [Program] section, select and load a machining file. For more details, see 3.13.3.
2) Press SF1 to enter [Auto] section→press F2 to enter simulation and track interface, as shown
below:
Fig. 3-35 Simulation and Motion Trace
3) In the interface shown above, press F1 to start simulation, with information displayed above the
track.
4) Press F2 to exit from simulation state.
To Next Page
Loading...
