Specialized Concentrated Focused
「72」Operation
3.15 System Management
3.15.1 System Info
Under [Diagnosis] function section, press F7 [System Info] to switch to system information interface, as
shown in Fig. 3-60, which displays the related information of NK200.
Fig. 3-60 System Information Interface
3.15.2 Register
In [System Info] screen of [System] function section, “registration code” can be used to register the
system and limit the system service time. Registration code is generated by the registration code maker.
Its generation steps are:
1) Double click the registration code maker “GetRegCode.exe”, and then enter the password
“ncstudio” (revisable) in the dialog box as shown in Fig. 3-61. Then press “OK”, input control card
serial number and limited service time, and then click “Generate” to generate a new code displayed
at the lower part, as shown in Fig. 3-62. If service time is not limited, input “-1” in the “limited time”
bar to generate an unlimited code. Service time is registered by days.
Fig. 3-61 Registration Code Maker-1
To Next Page
Loading...
