WEIHONG NK200 - Maintenance; Driver; Various Servo Driver Parameters

Specialized Concentrated Focused
「84」Maintenance
4 Maintenance
4.1 Operating System Maintenance ............................................................................................................85
4.1.1 Software Upgrade .................................................................................................................................... 85
4.1.2 Mirror Upgrade ........................................................................................................................................ 87
4.1.3 System Eboot ........................................................................................................................................... 87
4.1.4 Software Upgrade Interface .................................................................................................................... 88
4.2 Alarm Information .................................................................................................................................90
4.3 Common Troubleshooting .....................................................................................................................92
4.3.1 What should you do if the spindle does not rotate? ............................................................................... 92
4.3.2 What should you do if an axis does not move? ....................................................................................... 92
4.3.3 What should you do if servo motor of Z brake can’t be opened? ........................................................... 92
4.3.4 What should you do if machine tool returns to machine origin abnormally? ......................................... 93
4.3.5 What should you do if the machine tool motions upward after arriving at the position of tool presetter
during presetting? ........................................................................................................................................................ 93