Specialized Concentrated Focused
Operation「75」
processed under turntable mode
Start up speed of revolving
The max. speed of stepping motor to start
working directly without acceleration
Acceleration speed of
revolving
Under any circumstance, the acceleration of
rotation axis will not surpass this value. Its value
is decided by mechanical and electrical
characteristic of machine tool.
Under any circumstance, the velocity of rotation
axis will not surpass this value. Its value is
decided by mechanical and electrical
characteristic of machine tool.
Under turntable mode, Y axis acts as rotary axis. The parameter “Revolving axis radius” refers to
the radius of the workpiece to be processed, related with the programming diameter in the
processing file. If the value of this parameter is set incorrectly, the actual machining dimension will
be affected.
Parameters “Acceleration speed of revolving” and “Max speed of revolving” set the acceleration and
max. speed of rotary axis, related with mechanical characteristic of machine tool.
The parameter “Revolving axis unit” decides the unit for rotary axis, related with the unit in the file
programming. If “deg” is used in the programming, this parameter should be set as “False”; if “mm”
is used in the programming, this parameter should be set as “True”.
3.16 Auxiliary Function
3.16.1 Jiggle
Coordinate axes can be jiggled during processing with the help of “Jiggle” function. Only valid in auto
machining or pause state, this function is used to realize the fine tuning without stopping the machining.
Under [Auto] function section, pressing F5 will eject a dialog, as shown below.
To Next Page
Loading...
