WEIHONG NK200 - Handwheel Operation; Handwheel Mode

Specialized Concentrated Focused
Operation「69」
Parameter
Definition
Setting Range
Cycle times of ENG
processing
The needed cycle processing times in processing ENG
files.
None
Deep hole machining
Deep hole machining manner:0:reciprocating chip
removal; 1: high speed reciprocating chip removal
0, 1
Translation parameters of ENG file are applied to translation for ENG files, including “Tool lifting
height”, “Tool change prompt”, etc.
 Related parameter (PLT file)
Parameter
Definition
Setting Range
Tool lifting height
Tool lifting height in rapid traverse
0~100000 mm
Plt unit
In normal situation, 1plt=40mm.
0~100000 mm
Tool step
It refers to tool space in PLT machining and should be
confirmed by tool diameter. Only when adjacent tool
paths have overlapping part can the workpiece be
machined thoroughly.
0~100000 mm
Machining depth
Machining depth in plt files.
-
PLT file translation parameters are applied to translation of PLT files. PLT is a format of 2D
machining files defined by an American company Hewlett Packard (HP), usually used in
embossment and advertising carving, including such parameters as “retract”, “PLT units”, “tool
offset” and “cutting depth”. At the same time, PLT is a kind of unit. Normally, 1plt=40.195mm, which
can be magnified or reduced by setting the parameter “Plt unit”.
3.14 Handwheel Operation
3.14.1 Handwheel Mode
The system supports three operation modes: auto mode, reference point mode and manual mode, and
manual mode is subdivided into jog, stepping and handwheel.
Under [Manual] function section, press F2, F3, F4, F5 to enable different operation modes. And F5
corresponds to handwheel mode.