Specialized Concentrated Focused
「70」Operation
Fig. 3-57 Handwheel Interface
Under handwheel mode, users can configure a handwheel to control the machine tool. As shown in Fig.
3-58, select the motion axis by rotating “Axis selection button”, select handwheel override gear by
rotating “Gear selection button”, and control the selected axis running at the selected handwheel
override gear by rotating “Handwheel control rotation disk”. Handwheel override gear regulates the
displacement (linear displacement or rotation angle) of moving parts of machine tool per each grid
turning of handwheel.
Gear selection
button
Axis selection
button
Handwheel control
rotation disk
Fig. 3-58 Handwheel
To Next Page
Loading...
